What HHO Electrode should I use for my HHO - Brown's Gas Generator?

Plates:  very common and "old school" designed electrodes made of stainless steel.

                                    

Bolts: some very cheap designs use stainless steel bolts as electrodes. Not recommended. 

Wire:  A few designs use wired electrodes. The design is better than the plates, but the electrodes are above the water level which is dangerous. Not recommended. 

Tubes: the latest design are tubes in tubes. Depending on the non-corrosive grade of steel used this desing works very good and is highly recommended. "Joe Cell" alike design.   

                 H2ORSE Appaloosa 30

Helix: the latest design are tubes in tubes. Depending on the non-corrosive grade of steel used this desing works very good and is highly recommended. The Helix design seems to be close to the Stan Meyer HHO design.

              

The Helix ( at the right) is a non-corroding (water does not turn brown) specialty stainless steel electrode.
Available at: R o b  M a t t h i e s   Vancouver  ( 6 0 4 ) 7 3 9 - 7 7 1 7  HHO Vancouver.

 

 

 Back to Fuel Saver Page

Brownsgas.com 2004 - 2008

Top of Page