Electrical pulses, not electrolysis (recommended for plate setup only, BG.com)
By fuel-efficient-vehicles.org
Where normal water electrolysis requires the passage of current measured in amps, this cell achieves the same effect in milliamps. Furthermore, ordinary tap water requires the addition of an electrolyte such as sulphuric acid to aid current conduction with the standard electrolysis approach; these cells function at greatest efficiency with plain tap water.
According to the witnesses, the most startling aspect of the My'r cell was that it remained cold, even after hours of gas production.
My 'r experiments, which he seems to be able to perform to order, have earned him a series of US patents granted under Section 101. The granting of a patent under this section is dependent on a successful demonstration of the invention to a Patent Review Board.
My'r cell seems to have many of the attributes of an electrolytic cell except that it functions at high voltage, low current rather than the other way around. Construction is unremarkable. The electrodes --- referred to as "excitors" by Meyer --- are made from parallel plates of stainless steel placed in either flat or concentric arrangements. (see the washers, on the right, for the simplest method) Gas production seems to vary as the inverse of the distance between them; the patents suggest a spacing of 1.5 mm produces satisfactory results.
A witness team of independent UK scientifc observers testified that US inventor Sten My'r successfully decomposed ordinary tap water into constituent elements through a combination of high, pulsed voltage using an average current measured only in milliamps. Reported gas evolution was enough to sustain a hydrogen /oxygen flame which instantly melted steel. (How Denny Klein got started - see video)
"We did notice that the water at the top of the cell slowly became discolored with a pale cream and dark brown precipitate, almost certainly the effects of the chlorine in the heavily chlorinated tap water..." ... "We clearly saw how increasing and decreasing the voltage is used to control gas production. We saw how gas generation ceased and then began again instantly as the voltage driving circuit was switched off and then on again."
The use of a high voltage spike alone (1500 volts+), without the current being delivered through the liquid, will not cause the disassociation to take place. Once Stan's unit was made to begin breakdown (which takes 6 to 8 seconds) he was able to reduce both current and voltage to miniscule proportions.
There are two primary frequencies that produce the best results. They are: 14,372 Hz and 43,430 Hz. The former is about 50% more efficient, but it seems that just about any frequency between 9 KHz and 143,762 KHz works quite well. (1) This is because the nature of the wave form ( a spike ) is rich in harmonics and one of them is bound to be close to one of the two primary frequencies.
My'r was apparently eating dinner at a Grove City OH restaurant, when it is reported that he jumped up from the table, yelled that he'd been poisoned", and rushed out into the parking lot, where he collapsed and died. Theives came a week later and stole the the dune buggy and all of his experimental equipment, according to his twin brother, Stephen. Sten said while he was alive, that he was threatened many times and would not sell out to Arab Oil Corp`s. The Military was going to use this technology in their tanks, jeeps, etc. He had patents on his invention and was ready for production. Only $1,500 to equip your car! See the Videos above. No gasoline, just water. Sten said he was offered a billion dollars from an Arab to basically shelf his idea. Sten said, "No".
More information, plans and diagrams can be found on: http://fuel-efficient-vehicles.org/FEV-hydrogen-generator-build-one.php
Exact My'r pulse power circuit now available at Matthies Inc. Vancouver
Pulse power units are available at: http://www.pwmpower.com/ Florida, USA
Homepage
